Page tree

This page has not yet been translated to English.

Skip to end of metadata
Go to start of metadata

All sensors and actuators listed as compatible under Compatible products can be controlled and automated with everHome. In order for a 433 MHZ actuator to be switched to everHome, it must first be added as a device in the everHome portal and, if necessary, trained.

If a radio actuator receives data at a frequency of 433 MHz or 868 MHz, it is not necessarily compatible with everHome. Only 433/868 MHZ sensors / actuators listed as compatible under Compatible Products can be used in everHome. Feel free to contact our customer support if you have any questions. 

 

 

Content of this page

Step-by-step instructions
 

 

1. Registration with email address and password

Log in to a browser with your email address and password on the everHome portal. In the everHome portal, all your rooms, devices, groups, scenes, schedules can be easily and conveniently managed.



2. Click on the 'Devices' selection

You may already have devices in addition to your everHome CloudBox. If these devices have been created by the demo mode, you are welcome to delete them.




 

3. Add a new device

Add a new device by selecting 'Devices +'.





Select the appropriate manufacturer and, as a device model, the model name printed on the device. Give the new device a name under Name. Select the room to which the device is to be assigned. You can add new rooms under the 'Rooms +' selection. The room can also be reassigned to a device later at any time. Press the 'ADD DEVICE' button to create the device.

If the device works with house code and device code, then you accept these settings from the device. In this case, the device is now ready and can be switched.

If the device uses a random code, the learning process differs depending on the manufacturer and model. Please note the instructions for the teach-in process in the everHome portal and the operating instructions of the manufacturer. In most cases, within the first 5 seconds after inserting the intermediate connector / pressing the teach-in button on the device, the 'ON' button in the everHome portal must be pressed.

 

This teach-in process differs depending on the manufacturer and device model. Please read the operating instructions of the device manufacturer and follow the instructions in the everHome portal.






 
The device is now ready and can be switched.